[BlackLightz]

Hi all,

I got a simple question on how to make a T-joint on a spline. Or maybe u can aall it a continuation on an exsisting spline. Not 100% sure on the english termination.

First, look at the att. picture.

Here u see a simple spline with 3 points. All I want is to put in another line at the MIDDLE point and continue it upwards.

How do u do that?

Thx ahead


PS: I know about bringing in AI splines, but it bugs me to go that way for this small a task.

[UFOGoldorak]

Are you saying you can't draw another spline??

This post has been edited by UFOGoldorak: 09 March 2010 - 01:06 PM

[Rantin Al]

You cannot have a split in a spline. It can only have two end points.

You could add a second segment starting at the midpoint.

Please read the rules on attachment size and crop sample images to the relevant section.
A full screen capture of a simple spline is not necessary.

Alan.

[BlackLightz]

Ok, thx for the replys