Jump to content


Sign in to follow this  
rafidola

Extrude question

Recommended Posts

rafidola    4

Hello.
It's probably something simple but I have a single spline and there's a circular shape inside that spline which I expected to be subtracted when I extruded it but it didn't get subtracted.

q1.jpg

q2.jpg

Share this post


Link to post
Share on other sites

Cerbera    1,966

Are there 2 points in that bit of the spline not welded / closed ? If it's not that it's probably that there is some reason in the file that made this spline where the grouping is wrong, in which case you will have to split that inside bit off to a new spline, then spline mask it out of the original, if you see what I mean...

 

We'd need to have the file to give you more exact instructions...

 

CBR

Share this post


Link to post
Share on other sites
rafidola    4
  • Topic Author
  • 1 minute ago, Cerbera said:

    Are there 2 points in that bit of the spline not welded / closed ? If it's not that it's probably that there is some reason in the file that made this spline where the grouping is wrong, in which case you will have to split that inside bit off to a new spline, then spline mask it out of the original, if you see what I mean...

     

    We'd need to have the file to give you more exact instructions...

     

    CBR

    Aye. There were these damn overlapping points. I deleted them and now it's fine. I should've checked before I made this post. >.<
    Anyway, thank you for the support Cerb :)

    • Namaste 1

    Share this post


    Link to post
    Share on other sites
    Cerbera    1,966

    Lols. Occasionally gets the best of us, my friend ;)

     

    CBR

    Share this post


    Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    Sign in to follow this  

    • Recently Browsing   0 members

      No registered users viewing this page.

    ×