Jump to content

mulinskibros

How to make polygons on spline?

Recommended Posts

I have a spline, when I am extruding - it's ok, but without top and bottom  polygons.

And Bridge tool is deactivated.

 

What is the solution?

Screenshot_1.jpg

Share this post


Link to post
Share on other sites

  • Topic Author
  • 14 minutes ago, Igor said:

    You probably need to jump to an Attribute Manager and check the Tab where the caps setting are.

    No(

     

    Screenshot_2.jpg

    Share this post


    Link to post
    Share on other sites

    Your spline object is bunch of spline segments. Need to optimize at the first. Weld spline segments, enable "Close spline" option.(if you have it enabled now, extruded result will be messy, because all spline segments will be closed).

    If you don´t optimize spline, extruded result will not be connected, you´ll get same count of disconnected surfaces as spline segments...

    As you see on your spline, there is a lot of gradients between points from white to blue. Every gradient means separated segment. When you repair your spline, you create just single segment and you´ ll see just single gradient on whole spline. (you can check it like it looks like on simple rectangle spline converted to editable)

     

    On repaired spline apply extrude with zero extrusion value and enabled only start cap (disable end cap). When you convert object to polygons, you´ll get just "start cap" polygonal object...

    • Like 1

    Share this post


    Link to post
    Share on other sites

    Join the conversation

    You can post now and register later. If you have an account, sign in now to post with your account.
    Note: Your post will require moderator approval before it will be visible.

    Guest
    Reply to this topic...

    ×   Pasted as rich text.   Paste as plain text instead

      Only 75 emoji are allowed.

    ×   Your link has been automatically embedded.   Display as a link instead

    ×   Your previous content has been restored.   Clear editor

    ×   You cannot paste images directly. Upload or insert images from URL.


    • Recently Browsing   0 members

      No registered users viewing this page.

    YOUTUBE CHANNEL:

    ABOUT US:

    C4D Cafe is the largest CINEMA 4D community. We provide facilities for discussion, showcasing and learning our favorite software :)
    ×
    ×
    • Create New...