Jump to content
adamjm

modelling - joining shapes

Recommended Posts

Hi guys,

 

I'm trying to connect these two halves into one form. I've tried stitch and sew, but it doesn't line up the geometry correctly.

 

can anyone advise on this? They're not complicated shapes, they're both the same.

 

thanks

TBR3 testc4d.c4d

Share this post


Link to post
Share on other sites

Stitch and sew works fine for me. Its not entirely symmetrical not sure if that was your goal. Bit of tweaking and you could build it with symmetry and just build half.

 

Deck

 

 

Screen Shot 2019-02-05 at 12.46.56.png

Share this post


Link to post
Share on other sites

Agree that you could delete half and use symmetry. 

 

Or, align the points in Front view (see pic) on both ends, then bridge/stich/weld as desired.

 

117004252_ScreenShot2019-02-07at10_23_57AM.thumb.png.dbd647c52f1a396bcabf8cd2ec4b04d9.png

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • Recently Browsing   0 members

    No registered users viewing this page.

YOUTUBE CHANNEL:

ABOUT US:

C4D Cafe is the largest CINEMA 4D community. We provide facilities for discussion, showcasing and learning our favorite software :)
×
×
  • Create New...