Jump to content

Sign in to follow this  
Chip Johnson

Straighten out Cloth object

Recommended Posts

Hi, 

 

I have this basic project where a cloth object is on the face of an object, which is a logo of sorts.  Is there a way to edit the logo object so that the sharp angle at the bottom can straighten out and follow the cloth more naturally?  In the project file, the object of interest is Cap 1.

 

Project file is attached. 

 

Thanks!!!

GustDrums_G Cloth.c4d

Share this post


Link to post

Unfortunately your cap is a single N-gon.  First step would be to recreate that cap using Quads.  In your MoText object, go to the Caps tab, then at the bottom where it says "Type" switch it to "Quadrangles."  Check "Regular Grid" and set a width that gives your cap a decent amount of geometry (not too much so that your sim becomes extremely slow).  Then you can drop your Cap under a Cloth surface and subdivide it and add thickness.

Share this post


Link to post

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Sign in to follow this  

  • Recently Browsing   0 members

    No registered users viewing this page.

×
×
  • Create New...