Jump to content

Archived

This topic is now archived and is closed to further replies.

aneirin

Undo Set Initial State

Recommended Posts

  • Topic Author
  • once you have set initial state is there a way to get everything back their original positions? I have a bunch of objects with connectors, and I didn't realise that the connectors would stay in the same place so now the whole setup is ruined :(

    Share this post


    Link to post
    Share on other sites

    On the Dynamics tag disable it on the Dynamics tab. Move your object then press the "Set Initial State" button. Finally enable dynamics again.

    I think that's how you do it.

    3DKiwi

    Share this post


    Link to post
    Share on other sites
  • Topic Author
  • problem is I couldn't figure out how to get everything back to their original positions without moving them manually and lining it up by eye.

    but anyway I just rebuilt the thing from scratch rather than keep stressing over it.

    Share this post


    Link to post
    Share on other sites
    Guest
    This topic is now closed to further replies.

    • Recently Browsing   0 members

      No registered users viewing this page.

    ×
    ×
    • Create New...