Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 07/06/2020 in all areas

  1. I have been using "Set Selection" on many occasions. Be it to create selection tags to apply different materials to an object. Or simply as kind of a clipboard to temporarily hold a set of selected polygons during modeling. However, in most cases I do not have enough with a single selection tag. It can happen that during a modeling session I need a few temporary selections, to be picked up later in the process when I need to work here and there on a model. As such, in the past I had a love-hate relationship with the "Set Selection" command. It was a very useful tool, except that
    4 points
  2. And this one is pretty good as well:
    3 points
  3. This tutorial shows how you can do a dome with hexagonal segments.:
    2 points
  4. Yes, cogwheel has a lot of "too dependent" parameters while flower not enough, so this is why I use simple star. Just set number of peaks, set aproximately inner/outer radius, convert to editable and change type of spline from linear to B-spline...
    1 point
  5. examples from help (if it´s tell you something, especially last example to play with)
    1 point
  6. Create caps is problem, because in every extrrusion is created cap. Let´s imagine corridor. With every extrude with create caps enabled you´ll create wall between every extrusion. Visually it´s fine until you apply bevel on edges or SDS. Objects must have single surface...(like apple has peel only over surface not "inside" volume of apple)
    1 point
  7. You bought a dollar bill object? Isn't that... A rectangular plane?
    1 point
  8. I can confirm this is the case with S22.116 and that MAXON is already aware of this one. Hopefully a fix will be a long soon. But thanks for reporting... CBR
    1 point
×
×
  • Create New...